Service Guide
- Model 100 front view
- Model 200 front view
- Model 100 rear view
- Model 200 rear view
- Operator information panel
- Diagnostics panel
- LEDs on the Gigabit Ethernet Copper Adapter
- LEDs on the Gigabit Ethernet SX Adapter
- The ServeRAID-4H controller
- The ServeRAID-4L controller
- Locations of major components
- System-board options connectors
- System-board internal cable connectors
- System board switches and jumpers
- System board LED locations
- Removing the cover of the Model 100
- Removing the cover of the Model 200
- Removing the appliance door of the Model 100
- Removing the bezel of the Model 200
- Installing a hot-swap drive
- Replacing a drive in a hot-swap drive bay in the Model 100
- Installing a non-hot-swap hard drive
- Replacing a hot-swap power supply
- Removing a hot-swap power supply
- Installing a hot-swap power supply
- Installing a DIMM
- ServeRAID-4H controller
- ServeRAID-4L controller
- Inserting a ServeRAID-4H controller into the PCI expansion slot
- Connecting a ServeRAID-4H controller internal channel connector
- Connecting a ServeRAID-4H controller external channel connector
- Attaching a Gigabit Ethernet Copper Adapter
- Attaching a Gigabit Ethernet SX Adapter
- Replacing a microprocessor
- Replacing the fan assembly
- Replace the Model 100 cover
- Replacing the Model 200 cover
- Replacing the Model 100 bezel
- Replacing the Model 200 bezel
- Input/output connectors (ports) and expansion slots
- Auxiliary-device port
- Rack mounting template
- Service port pin layout
[ Top of Page | Previous Page | Next Page | Table of Contents | Index ]