IBM Tape Library SMI-S Agent 1.1.1 Release Notes

Introduction
------------
Release 1.1.1 is a maintenance release for the IBM Tape Library SMI-S Agent.  
All changes contained in this release are for the IBM 3584 Tape Library Device.
See the Minimum Requirements section in this document for Tape Device firmware 
requirements.

Install/Upgrade
---------------
For complete installation and upgrade instructions, refer to the "SMI-S Agent 
for Tape on Linux Systems Installation guide" located in SMI-S/doc directory.  
Refer to the notes section below for additional installation and configuration 
instructions.

You may also upgrade from Release 1.1.0 to Release 1.1.1.  The installation
utility will automatically detect the earlier installed version and upgrade 
to Release 1.1.1 after confirmation.

Minimum Requirements
--------------------
In addition to the prerequisites contained in the Installation Guide, the 
following Tape Library firmware levels are required for the fixes contained
in the SMI-S agent release to work correctly.

  IBM 3584 Tape Library firmware level: 5550 or later
  IBM LTO Ultrium 3 tape drive firmware level: 59D2 or later

Tape library firmware can be found online at:

  http://www.ibm.com/servers/storage/support/lto/3584/downloading.html

Fixes in Release 1.1.1
----------------------

defect   Description
------   ---------------------------------------------
17375    Indication support insufficient

         Tape library alerts are now implemented as defined in the SNIA 
         SMI-S 1.1.0 Storage Media Library (SML) profile. 

17376    FC Target subprofile not fully implemented.

         The FC TargetPort subprofile is now  implemented as defined in the 
         SNIA SML 1.1.0 profile.

18432    The reference to TIC in the snmptrapd.conf needs to be a fully 
         qualified pathname.

         The path for TIC program in the snmptrapd.conf is now updated with 
         the full path depending on the install directory. 


Open Issues Release 1.1.1
-------------------------
In this release the SMI-S SML 1.1 profile core classes are implemented.   Full 
SMI-S SML 1.1 profile compliance and certification is scheduled for a future 
release.


Notes for Release 1.1.1
-----------------------
The 3584 tape library needs to be configured to deliver SNMP V2C traps to 
the IP address of the machine where the SMI-S Agent is installed.  See your
tape library documentation on how to configure the tape library SNMP 
trap destinations.