The following sections contain information about administering the .
Code updates are installed from a local FTP server connected to the
appliance. This FTP server must support anonymous FTP.
When you are servicing or troubleshooting the , you might need to
attach a keyboard and monitor to the appliance. Attach the monitor to
the VGA port, and attach the keyboard to the keyboard port located on the back
of the appliance.
The Recovery CD (in conjunction with the Recovery
Boot diskette) enables you to load the system image from an anonymous FTP
server. Before attempting to recover the appliance, attach a serial
console or equivalent device to serial port A of the appliance using a
null-modem cable.
Use the following communication settings to configure the serial
console:
19200 baud
8 data bits
No parity
1 stop bit
Refer to the IBM TotalStorage IP Storage 200i Administrator's Guide for complete procedures on recovering the appliance.
After you create a virtual logical unit (VLUN), you cannot change its size.
You cannot delete individual VLUNs; however, you can remove all VLUNs in a logical disk. Note that all data is lost when you delete the VLUNs.